Tubing (Gas Booster) Nylon
M33561
Items required; Measure your old atomizer sight tube and cut the new one to the same length. Remove old sight tube by cutting or pulling it from the atomizer and clean off old glue using Methylated Spirit. Apply a small amount of gorilla glue on the bottom and top of the connecting nipple enough to coat the surface. Fit the sight tube onto the bottom and top and leave to dry for approximately half an hour. Weight: 2g
- 1 x K33143 Scalpel Precision Knife Set
- 1 x Gorilla Glue
- 1 X Methylated Sprit C4357
- This also fits Hydro Gem, Sherwood Micro Welder, and Aqua Flame
- Outer diameter Ø8.00mm
- Inner diameter Ø5.00mm
£1.25
100MM
Quantity Discounts
| £1.25 when you buy 1 |
| £1.18 when you buy 2 or more |
